Audio Pro STEREO TWO Operations Instructions download pdf (Page 20)

20

TROUBLESHOOTING

If a unit does not function or perform as expected, the problem is not always a mechanical one. The

solution may be found in the table below. Check here before you contact your retailer or authorized

service center

Symptom: Possible cause: Possible correction:

Absence of sound * Speaker cables not connected * Connect according to the diagram on page 10

* Volume set at minimum * Turn up the volume

* Muting activated *Turn up the volume or press the muting button

on the remote control

* Headphones are connected * Turn the volume to minimum and disconnect

the headphones

No sound from the left or right speaker * The speaker cables are not connected * Connect the cables according to the diagram

on page 10

Timer does not work * Times have not been set * Set the timer times. See page 17

* There was a power outage * Set the timer times. See page 17

* The timer function is not activated * Activate the timer. See page 17

The time is not displayed * There was a power outage * Set the current time. See page 11

* The main power switch was turned off * Set a radio station using RDS/CT

Poor or absent FM reception * The FM antenna is not connected *Connect the FM antenna. See page 1

* No stations are set * Find correct frequency. See page 13

* AM chosen as frequency * Select FM Stereo as the frequency. See page

13

No FM stereo reception * FM Mono or AM chosen as frequency * Select FM Stereo as frequency. See page 13

A pre-set station can not be accessed * No broadcasting * Wait for a broadcast from the station

* Station erased from memory * Search for the station and pre-set it again

Poor or absent AM reception * The AM antenna is not connected *Connect the AM antenna. See page 11

A CD does not play * The CD is upside down * Put the CD in the tray with the label face up

* The CD is very dirty * Carefully clean the CD

* The CD is very scratched * Try a different CD

* Condensation on the optical lens * If the unit has been subjected to extreme tem

perature fluctuations, do not use it for a while

* Another audio source selected * Select CD with the SOURCE button or press

PLAY

Remote control functions poorly or not at all * The batteries are burned out * Install new AAA batteries

* The battery polarities are incorrect * Insert the batteries according to the diagram

in the battery compartment

* Out-of-range usage * Use the remote control within its range. See

page 11

* Remote control not aimed at the front panel * Aim the remote control toward the front panel.

Audio Pro STEREO TWO Operations Instructions Page 20